Please note: With the firmware version in this example, the sampling rate could not be changed via Step 4 – Install Apps Set the latency to the lowest value possible. In this example the following settings and Dante firmware/software versions have been used All further settings will be made via the iPad. In the following we use the KLANG:fabrik as an example.įrom now on, the computer is not required any more. With the Dante controller route all 32 outputs from the D元2R Dante card to KLANG:fabrik or 24 input channels to your KLANG:vier. You might want to optimize the settings later on according to your needs. In this way, all network ports are equally treated. Make sure the switch configuration settings for the D元2R Dante card and for KLANG:fabrik / KLANG:vier are all set to “Switched”. Connect your computer with an Ethernet cable to your Wifi router.Run a network cable from Dante A of the D元2R to Dante 1 of KLANG:fabrik.Run a network cable from KLANG:fabrik / KLANG:vier (Control/net port) to your Wifi router.Remove this card and install the Mackie Dante expansion card to your D元2R according to the instructions from Mackie.įor more information refer to the Mackie D元2R website Step 2 – Connect all Devices The D元2R comes with a pre-installed network expansion card with a Wifi control network port only. Computer (Windows Mac) with Dante Controller (for more infos click here…).Here are details on the setup and an interview with guitarist Pontus Norgren. by the Swedish Heavy Metal Band HammerFall. In this article we will show how to connect the Mackie D元2R via Dante to KLANG:fabrik / KLANG:vier and how easy it is to adapt this workflow for your band. The combination of a rack-mixer with a KLANG 3D In-Ear Mixing system is very powerful.

Mackie master fader 5 download